Combine harvester front attachments

A range as diverse as your requirements.

Front attachments

Combine harvester front attachments

A range as diverse as your requirements.

Convenient front attachment features.

Front attachments

Automated reel control.

  • Circumferential reel speed is adjusted automatically in proportion to the ground speed
  • Infinitely variable adjustment and storage of reel speed (between forward, synchronous and after-running settings) relative to the ground speed in CEBIS
  • Speed settings can be stored in CEBIS
  • Hydraulic overload protection prevents damage
Front attachments

Automatic adjustment.

The operator can use the multifunction control lever to store up to four separate combinations of settings. The currently active and the stored combinations of settings can be viewed continuously in CEBIS.

Each combination of settings consists of:

  • Reel height
  • Reel levelling setting (VARIO cutterbar)
  • Table length (VARIO cutterbar)
  • Cutting height (with AUTO CONTOUR)
  • Cutting angle (HP feeder housing)

All the individual parameters can be overridden manually by the operator at any time, either by a direct input with the multifunction control lever or via CEBIS.

Front attachments

VARIO automation.

  • VARIO automation can be switched on or off in CEBIS
  • The table length and reel level are then activated or deactivated together

Advantages for you.

  • Reduction in operator workload through automatic application of multiple settings for front attachment
  • Optimal adaptation to conditions by means of up to four combinations of settings - for changing crop conditions (such as lodged crops / standing crops) or headland operation and edge mowing - which can be saved separately
  • Can be overridden by the operator at any time
Front attachments

Automatic parking and transport mode.

  • Pressing the cutting height adjustment button causes the cutterbar to move automatically into position for stowage on the trailer
  • Table moves to 0 mm position (without rapeseed knives)
  • Table moves to 450 mm position (with rapeseed knives)
  • Reel moves all the way down and to the rear
  • In the case of MAXFLEX cutterbars, the knife bar is set to a rigid configuration electrohydraulically (grain harvesting)
  • Activation procedure, which takes place with the threshing system switched off, varies depending on speed: Above 2 km/h: cutting height adjustment button is pressed once; Below 2 km/h: AUTO CONTOUR button is held down
Front attachments

Automatic operating position.

  • Pressing the cutting height preselection button causes the cutterbar to move to the last operating position automatically
  • Table moves to last operating position
  • Reel moves to last operating position
  • In the case of MAXFLEX cutterbars, the knife bar is released (no longer set to rigid configuration) electrohydraulically (soybean harvesting)
  • Activation procedure varies depending on speed: Above 2 km/h: cutting height adjustment button is pressed once; Below 2 km/h: cutting height adjustment button is held down
  • Reel moves to last operating position
  • Table moves to last operating position

Advantages for you.

  • Transport and operating positions are reached quickly and easily
  • No need to take account of mechanism dependencies